Pusher 3.5" MEGA Intake System with Intercooler Tubes for 2013- 2018 Ram Cummins (Green)

Pusher 3.5" MEGA Intake System with Intercooler Tubes for 2013- 2018 Ram Cummins (Green)

The Pusher 67KIT3GWHP 3.5" MEGA Intake w/ Pass Side Intercooler Tube for your 6.7 Dodge 6.7L Cummins is built around a 3.5" inlet that smoothly transitions to two 3" mandrel bent tubes. This design also enabled the use of a...

$ 680.00
  • Category: Cummins 2013 – 2018 6.7L Cold Air Intakes & Manifolds, Cummins 2013 – 2018 6.7L Intercoolers / Cooling Systems
The Pusher 67KIT3GWHP 3.5" MEGA Intake w/ Pass Side Intercooler Tube for your 6.7 Dodge 6.7L Cummins is built around a 3.5" inlet that smoothly transitions to two 3" mandrel bent tubes. This design also enabled the use of a short bolt in place of the long driver-side flange bolt that passes right through the center of the stock manifold air plenum. Thus freeing up airflow even more yet maintaining the stock six bolt pattern for a proper seal. The twin tube design nearly doubles the outlet size of the stock manifold while minimizing the impact of the initial section of the number one injector line. These design features amount to a 49.4% increase in flow over the factory manifold. With this vast improvement over the stock manifold you can expect quicker turbo spool, lower EGT's, and less over all strain on your motor. This manifold also includes instructions, a polished stainless dipstick mount, port plugs, a factory Cummins gasket and hardware to make installing this intake extremely easy. 

The Pusher intercooler tubes are built around 3.5" mandrel bent .060" thick tubing. These tubes help optimize your factory intake plumbing by replacing the stock 2.75" ID driver and passenger-side tube. This kit also includes heavy duty 4-ply silicone couplers and stainless T-bolt clamps to make installing these tubes extremely easy. When using this kit, you do not have to try and cut the factory steel bands off the factory tubes in order to save the factory boots. Just loosen the factory clamps and install the supplied parts.

Features :
  • By replacing your restrictive factory system with a Pusher Intake System, you can expect results of:
  • 50-200 degree Fahrenheit drop in EGT's
  • .5-1 MPG increase
  • Significant gain in throttle response
  • Faster turbo  spool